Nero Techsuit Fit

blueseventy Competition Swimwear is designed to fit extremely tight in order to offer the most compression in order to reduce drag, provide dynamic lift and help propel you forward. We utilize the latest in modern textile fabric technology with advanced ultrasonic welding to create the fastest possible swimwear. 

Due to the high competitive design of the technical swimsuits, they are not easy to get on. These are not your everyday swimwear that you can simply slip into, time and care must be taken for a proper, comfortable fit. 

Jump to: KNEESKIN FIT | JAMMER FIT

Follow these instructions for getting into your Nero Jammers or Kneeskin successfully before your race. 

FITTING YOUR KNEESKIN

Expect at least 10-15 minutes time to properly get into your Nero Kneeskin. Make sure to take your time, working the suit up slowly. Pull on seams or double layered panels whenever possible to limit damage to the performance fabric. Most importantly, watch your fingernails! Keep nails trimmed and use the pads of your fingers to grip and pull material to avoid any tears. 

Make sure you are fully dry before starting to put on your tech suit.

  1. Flip up the leg grippers and insert your first leg into the suit. Work it up above the knee before carefully inserting your second leg. Slowly work the suit up your legs. 
  2. Slowly pull up on the back and side seams to work up your thighs and over your hips. Take your time, this is likely the longest part of getting the suit on. 
  3. Ensure the fit is correct on the hips and crotch before continuing on. The liner should ride high on your hips and across your butt (rather than under it). This promotes a better body position, aiding in a faster swim.
  4. Continue to work the suit up your body as far as it will go.
  5. Slide your arms into the suit next, one at a time. It is recommended to slide your arms in elbow first, which makes it easier to get on and stretches the fabric less. 
  6. Once both arms are in, check that the suit is sitting properly around your chest and torso, carefully adjusting the fit as needed.
  7. Lastly flip the leg grippers back over and pull any excess fabric down the leg. 
  8. Now you're ready to race!

 

FITTING YOUR JAMMER

Expect about 5 minutes time to properly get into your Nero Jammer. Make sure to take your time, working the suit up slowly. Pull on seams or double layered panels whenever possible to limit damage to the performance fabric. Most importantly, watch your fingernails! Keep nails trimmed and use the pads of your fingers to grip and pull material to avoid any tears. 

Make sure you are fully dry before starting to put on your tech suit.

  1. Step into the suit, one leg at a time and work the suit up your legs. Make sure to flip up the leg grippers to help the suit slide up your legs. 
  2. Work the suit up your legs, using your finger pads to work the material up carefully, keeping both sides even. 
  3. Work the suit up over your hips and into the crotch, ensuring that the fit is correct before continuing. 
  4. Place your hand down the rear of the suit with your palm facing away from your body. Push out and pull up to help get the suit into proper position around your hips. 
  5. Flip the grippers down and pull down to remove any excess fabric bunches. 
  6. Now you're ready to race!